I made sure to select the ‘Target is an SSD’ option, to ensure correct 4K Alignment. I was able to get round the problem by using Easeus Disk Copy Pro in ‘Sector by Sector’ mode, which took around 20 hours, and appeared to complete successfully. However, with the drive now failing, this was the push that I needed! So I ordered a 2TB Samsung EVO 870, attached it to the machine using a Startech USB-to-SATA cable, formatted it to test that everything was OK, then set about cloning the failing 2TB HDD onto it.Īs expected, I was unable to clone the drive using Easeus Partition Master, because the same ‘sector could not be read’ error appeared every time. I had been planning to migrate the old WD Black onto an SSD for some time, but kept putting it off. I knew that the drive had begun to fail, and that I needed to act fast. A whole raft of errors then started to appear on CHKDSK, and during a surface scan of the drive in Partition Master. When I returned, I noticed that Partition Master would no longer allow me to clone the data drive, instead producing a ‘Sector Could not be Read’ error practically straight away. Last October I went away on holiday to Turkey for a week, and I stupidly shut the machine down. The data is copied onto an external USB drive – a 2TB Western Digital Passport Ultra. Over the years I have employed various backup solutions, but most recently, I have been using Easeus Partition Master and Easeus Disk Copy Pro to perform a full clone of my D: drive on a regular basis. The machine runs Windows 11, which resides on a 250GB Samsung 860 PRO SSD. The WD Black contained my life-long data, formatted as a single NTFS partition of 1.82TB, and was basically my ‘Master Data’ drive. Again, I put this down to leaving the drive running undisturbed, 24/7. That too has lasted incredibly well, with over 80,000 hours of runtime on the clock. During that time, with the exception of a power supply failure, it has never missed a beat.Īt the time of purchase, I replaced the OEM Seagate hard disk drive with a nice Western Digital 2TB Black, 7200RPM. Apart from a couple of years spent in storage, the machine has been left running literally 24/7 since it was new. I would like to ask for some help relating to a cloning issue, which is doing my head in!īut first, some short background here: I have a 12-year old Dell OptiPlex 990 SFF, purchased in 2011.
0 Comments
Leave a Reply. |